Underfloor measuring system
This system, used mainly in the automotive sector, permits measurement not only from both sides (duplex method) but also from below, thus permitting inspection of the lower running-gear area, for example.

Mobile measurement
…can be assured by means of various movable guide benches developed by MORA. Motion can be accomplished using air-cushions, for example, and also using simple workshop jacks. Alignment is accomplished either manually or using an automatic leveling unit.

"Flying" coordinate measuring system
Setting up a complete measuring system anywhere at all and packing it back into the container after use – that is the task here. The measuring system has been constructed a number of times for a major motor-vehicle manufacturer. From the machine to the office, from the installation tools to the crane: …everything neatly stowed in the container!

"Suspended" coordinate measuring system
This machine type is necessary for certain special ambient conditions. Suspended, so to speak, from above, it describes a measuring range of 1.800mm x 2.500mm x 5.500mm

Rotary table special design
A combination of a rotary table with a MORA horizontal measuring system is shown here. The dimensions are considerable: 500 mm in height and 5600 mm in diameter for the rotary table alone.